Mounting The Charger On A Wall; Led Diagnostics; Leds On The Garden Pruner - Stihl GTA 26 Instruction Manual

English
To charge the battery:
1
► Push the battery (1) into the charger (2) until it stops.
The LED on the charger (3) glows or flashes green when
the battery is charging.
When the LED on the charger goes out, the charging
process is complete and the charger will shut itself off. The
battery can be removed from the charger.
► Disconnect the power supply cord from the electrical
outlet when the charger is not in use.
A battery is not fully charged when it ships from the factory.
STIHL recommends that you fully charge the battery before
using it the first time.
Operate the charger indoors in a dry room. For optimum
performance, STIHL recommends operating the charger
within an ambient temperature range of 41 °F to 86 °F (5 °C
to 30 °C).
The battery heats up during operation. If a hot battery is
inserted into the charger, it may be necessary for it to cool
down before charging starts. The charging process begins
only after the battery has cooled down sufficiently.
Charging time depends on a number of factors, including
battery condition and the ambient temperature. For a
complete list of approximate charging times, see
www.stihl.com/charging-times.

11.3 Mounting the Charger on a Wall

When mounting, ensure that no electrical cables, pipes or
other service lines run in the wall behind the charger.
22
2
3
To mount the wall charger:
2
1 b
c
a
► Mount the charger indoors in a dry room near an electrical
outlet.
► Sink the screws into a wall stud. Use appropriate screw-in
wall anchors or other similar mounting devices if an
appropriate wall stud is not available.
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a = minimum 18 in. (450 mm)
– b = minimum 3.9 in. (100 mm)
– c = 2.1 in. (54 mm)
– d = 0.2 in. (4.5 mm)
– e = 0.4 in. (9 mm)
– f = 0.1 in. (2.5 mm)

12 LED Diagnostics

12.1 LEDs on the Garden Pruner

12.1.1 Garden Pruner Status
The LEDs on the garden pruner show the status of the power
tool.
If three LEDs glow red continuously: the garden pruner
motor is too hot. Allow the motor to cool down.
12 LED Diagnostics
3
e
d
f
f
0458-694-8621-A