Stihl MSA 160 T Instruction Manual page 56

English
Fitting the saw chain
WARNING
Put on protective gloves – risk of injury
by the sharp cutters.
Fit the chain starting at the nose of
N
the guide bar
54
Fitting the guide bar
1 1
3
2
Position the guide bar over the
N
bolts (1) – the cutting edges of the
saw chain must point to the right
Position the locating hole (2) over
N
the peg of the tensioner slide –
simultaneously place the saw chain
over the sprocket wheel (3)
3
Turn screw (3) to the right until there
N
is very little chain sag on the
underside of the bar – and the drive
link tangs engage in the bar groove
Refit the chain sprocket cover and
N
then screw on the nut by hand until
it is finger-tight
Go to chapter "Tensioning the
N
Chain"
MSA 160 T