Table of Contents
Advertisement
Figure 7. B08S and B16S switch fabric module
LEDs on the switch fabric module
The front panel provides status information using the LEDs listed in Table 6.
Interface modules
This section describes the interface modules for the following:
v The B08S, in which you can install up to eight Interface modules in the slots
v The B16S, n which you can install up to 16 interface modules in the slots shown
Note: You cannot mix IPv4 and IPv6 modules together in the same chassis.
Table 7 lists the supported Interface modules for each type.
Table 7. Interface modules
Interface Module
IPv4 Interface Modules
24-port 10/100/1000 Mbps Ethernet RJ45 copper without POE
24-port 100/1000 Mbps Ethernet SFP
2-port 10 Gbps Ethernet XFP
IPv6 Interface Modules
IPv6 24-port 10/100/1000 Mbps Ethernet RJ45 copper without POE
IPv6 24-port 100/1000 Mbps Ethernet SFP
IPv6 2-port 10 Gbps Ethernet XFP
Hot swap support
The B08S and B16S support Multi-Service IronWare R05.0.00a and later. Enhanced
Hot Swap is supported, meaning you can remove and replace the interface
modules without powering down the system, and without executing the disable
module command. However, it is recommended that the modules be disabled
through the CLI before removal from the chassis.
Table 6. Front panel switch fabric LED status
LED
Description and Position
Pwr
Top-most LED
Active
Bottom-most LED
shown in Figure 2 on page 7.
in Figure 4 on page 9.
Pwr
Active
State
Meaning
On (Green)
The module is receiving power.
Off
The module is not receiving power.
On (Green)
The module is functioning properly.
Off
The module is not functioning properly.
B08S
X
X
X
X
X
X
B16S
X
X
X
X
X
X
Chapter 2. Product Overview
13
Advertisement
Table of Contents
