Connecting Ac Power To The Chassis; Original Power Supplies - IBM s-series Installation And User Manual

Figure 51. Original power supplies
Note: For the differences between the replacement and original power supplies,
To install an original power supply, do the following:
1. Release the latch on the front of the new power supply to unlock it:
2. Insert the new power supply into the empty power supply slot.
3. When the power supply is fully seated, the power supply latch will catch onto a
4. Connect power to the chassis. See "Connecting AC power to the chassis."

Connecting AC power to the chassis

AC power is supplied though an AC power cord that is installed at the rear of the
chassis.
1. At the rear of the chassis, locate the power receptacle where the power
2. Lift the cord-retainer and connect the AC power cord to the power supply.
3. Snap the cord-retainer over the power plug to hold it in place, as illustrated
112
Ethernet Switch s-series Installation and User Guide
EJE CT S YS
see "About replacement power supplies" on page 21
v Locate the 1/2 inch tab (latch release) on the bottom center of the front of the
power supply.
v Firmly press on the latch release.
v The latch should spring open.
v Gently push the latch to the right.
Attention: Do not attempt to install the power supply without first releasing
the latch on the front of the power supply. Attempting to install the power
supply with a closed latch will result in mechanical damage to the power
supply and power supply slot.
Attention: Make sure the power supply is properly inserted in the slot. Never
insert the power supply upside down.
tab located on the right side of the power supply slot. Once the power supply is
fully seated, push firmly on the power supply latch until it locks the power supply
into place.
supplies have been installed.
below.
EJE CT POE