IBM s-series Installation And User Manual page 115

0d14h43m23s:N:System: Fan speed changed automatically to 3
0d14h43m20s:I:System: Interface ethernet 5/2, state up
0d14h43m19s:I:System: Interface ethernet 3/2, state up
0d14h43m19s:I:System: Interface ethernet mgmt1, state up
0d14h43m19s:I:System: Interface ethernet 6/13, state up
0d14h43m18s:I:System: Interface ethernet 4/1, state up
0d14h43m18s:I:System: Interface ethernet 2/13, state up
0d14h43m18s:N:System: Fan speed changed automatically to 2
0d14h43m18s:N:System: Fan speed changed automatically to 2
0d14h43m18s:N:System: Fan speed changed automatically to 2
0d14h43m18s:N:System: Fan speed changed automatically to 2
0d14h43m18s:N:System: Fan speed changed automatically to 2
0d14h43m18s:N:System: Fan speed changed automatically to 2
0d14h43m18s:I:System: Interface ethernet 1/13, state up
0d14h43m16s:N:powered On switch Fabric
0d14h43m09s:N:powered On switch Fabric
0d14h43m01s:I:Mgmt CPU1 slot 9 failed
0d14h43m01s:I:System: Warm start
0d14h43m01s:I:SNMP: read-only community added by from session SX 800
This output displays that one switchover occurred.
89
Chapter 6. Using a redundant management module