Leds - IBM RackSwitch G8264T Installation Manual

LEDs

Table 4. System LED descriptions
Function
Total Power Failure
Service Required
Power Supplies OK
Power Supply Failure
Fans OK
Fan Failure
Stack Master
Stack Backup/Member
Stack Error
Non-Stack Member
Operations Command
Note 1: If service required due to a power supply failure, this LED flashes. Otherwise, it is steady green.
Note 2: If service required due to fan failure, this LED flashes. Otherwise, it is steady green.
Note 3: If service required due to stacking error, this LED flashes or is steady green, depending on its last known good
state.
Note 4: If an operations command is sent to the unit, this LED is steady blue. It can be used to locate the device.
12
RackSwitch G8264T: Installation Guide
Two LED stacks provide system status and port link status. The following illustration
shows the system LEDs.
Mgmt
S
The system LEDs are described in the following table:
!
Service indicator
Power supplies and power input status
Fans status
S
Stacking indicator
The following table describes the system LED indications:
Service Power supply
Off Off
Flash blue Flash green (Note 1)
Not applicable Steady green
Flash blue Flash green
Not applicable Not applicable
Flash blue Not applicable
Off Not applicable
On Not applicable
Flash blue Not applicable
Off Not applicable
Steady blue Not applicable
(Note 4)
Fans Stacking
Off Off
Flash green (Note 2) Flash green or steady
green (Note 3)
Not applicable Not applicable
Not applicable Not applicable
Steady green Not applicable
Flash green Not applicable
Not applicable Flash green
Not applicable Steady green
Not applicable Flash green or steady
green
Not applicable Off
Not applicable Not applicable