Table of Contents
Advertisement
Figure 34. Installing a management module in the B16S
Replacing a switch fabric module
This section provides information about the following tasks:
v Removing a switch fabric module
v Installing a new switch fabric module
Removing a switch fabric module
You can remove a switch fabric module from the chassis while it is powered on and
running.
Before removing a switch fabric module from the chassis, have the following on
hand:
v An ESD wrist strap with a plug for connection to the ESD connector on the
v A #2 Phillips-head or flathead screwdriver.
To remove a switch fabric module from the chassis, do the following:
94
Ethernet Switch s-series Installation and User Guide
chassis.
CAUTION:
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm
resistor.
Advertisement
Table of Contents
