Yamaha RX-V2700 Owner's Manual page 19

FRONT terminals
Connect front left and right speakers to these terminals.
CENTER terminals
Connect a center speaker to these terminals.
SURROUND terminals
Connect surround left and right speakers to these
terminals.
SURROUND BACK terminals
Connect surround back left and right speakers to these
terminals.
Note
When you use a surround back speaker, connect the speaker to the
left SURROUND BACK terminal (SINGLE).
PRESENCE terminals
Connect presence left and right speakers to these
terminals.
SUBWOOFER jack
Connect a subwoofer with a built-in amplifier (such as the
YAMAHA Active Servo Processing Subwoofer System)
to this jack.
Connecting the speaker cable
1
Remove approximately 10 mm of insulation
from the end of each speaker cable and then
twist the exposed wires of the cable together
to prevent short circuits.
10 mm
2
Loosen the knob using the supplied speaker
terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
CONNECTIONS
17
En