Yamaha RX-V2700 Owner's Manual page 141

After Auto Setup
Warning message
W1:Out of Phase
W2:Over Distance
W3:Level Error
W4:SP Mismatch
Notes
• If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "Auto Setup" again.
• If warning "W1" appears, corrections are made, but they may not be optimal.
• If warning "W2" or "W3" appears, no corrections are made.
• If error "E10" occurs repeatedly, please contact a qualified YAMAHA service center.
Cause
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the speaker and the
listening position is over 24 m.
The difference of volume level among
speakers is excessive.
The result of the wiring check of "Auto
Setup" is different from "Speaker Set" in
"Manual Setup".
Remedy
Check the speaker connections for proper
polarity (+ or –).
Bring the speaker closer to the listening
position.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
Use speakers of similar quality.
Adjust the output volume of the subwoofer.
Use "Speaker Set" in "Manual Setup" to
adjust the speaker settings manually.
TROUBLESHOOTING
See
page
16
—
—
16
—
35
96
139
En