Yamaha RX-V2700 Owner's Manual page 126

USING MULTI-ZONE CONFIGURATION
INPUT
AMP
SOURCE
TV
Select TUNER as the input source to use the TUNER
features in the selected zone. For details about the TUNER
operations, see "FM/AM TUNING" on page 56.
Note
The selected input source is shared across all zones.
y
• You must complete this step within 5 seconds while the selected
zone flashes in the front panel display. Otherwise, the currently
selected zone mode is automatically canceled. In this case, press
ZONE CONTROLS on the front panel again.
• When a video monitor is connected to one of the ZONE VIDEO
jacks, you can display the control information of Zone 2 or
Zone 3 on the video monitor screen. Set "Zone OSD" to
"Zone2&Zone3" or "Zone2" (see page 103).
Adjusting the volume level of Zone 2 or
Zone 3
Rotate VOLUME on the front panel (or press
VOLUME +/– on the remote control) to adjust the
volume level of the selected zone.
VOLUME
y
Press MUTE on the remote control to mute the sound output to
the selected zone.
124
En
or
NET/USB
PHONO TUNER CD MULTI CH IN
V-AUX/DOCK CBL/SAT MD/TAPE CD-R
DVR/VCR 2
DTV VCR 1 DVD
+
or
VOLUME
–
Note
When you use the external amplifiers in Zone 2 or Zone 3,
VOLUME +/– can be used only when "Zone2 Volume" or
"Zone3 Volume" is set to "Variable" in "Zone2 Set" or "Zone3
Set" (see page 104).
Adjusting the balance of the speaker
level in Zone 2 or Zone 3
Press TONE CONTROL repeatedly to select
"BALANCE" and then rotate PROGRAM on the
front panel to adjust the balance of the front left
and right speaker level of the selected zone.
TONE
CONTROL
Adjusting the tonal quality of Zone 2 or
Zone 3
Set the operation mode selector to AMP and then
press CH +/– on the remote control to adjust the
high-frequency response (TREBLE) or
TV VOL +/– to adjust the low-frequency response
(BASS) respectively.
AMP
SOURCE
TV
y
You can also adjust the tonal quality of Zone 2 or Zone 3 by using
TONE CONTROL on the front panel. For details, see "Adjusting
the tonal quality" on page 52.
Note
Check that "ZONE 2" or "ZONE 3" is displayed in the display
window of the remote control before you adjust the tonal quality
of the corresponding zone (see page 123).
PROGRAM
+
TV VOL
–
BASS
+
CH
–
TREBLE