G0735 Flex Shaft Assembly; Power Connection; Connecting Power; Disconnecting Power - Grizzly G0734 Owner's Manual

G0735 Flex Shaft Assembly

1. Remove the cap shown in Figure 12.
Figure 12. Flex shaft cap location.
2.
Insert the inner spindle into the threaded
shaft, then thread on the flex shaft, as shown
in Figure 13.
Threaded Shaft
Inner Spindle
Figure 13. Installing flex shaft.
3. Insert the included drill bit or a tool bit (not
included) into the flex shaft collet.
4.
Insert the L-wrench into the hole on the collet
and tighten the bit with the collet wrench, as
shown in Figure 14.
Collet
Drill Bit
Collet
Wrench
Figure 14. Securing drill bit in flex shaft collet.
-16-
Cap
Flex Shaft
L-Wrench

Power Connection

After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.

Connecting Power

1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
Figure 15. Connecting power.

Disconnecting Power

1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
Figure 16. Disconnecting power.
Model G0734/G0735 (Mfd. Since 12/15)