Inventory - Grizzly G0734 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1: (Figure 4)
A. Blade Guard ............................................... 1
B. Blade Adapters .......................................... 2
C. Pin-End Blade 18 TPI ................................. 1
D. Hex Wrench 3mm ....................................... 1
E. Hex Wrench 2.5mm .................................... 1
F. Pin-End Blade 15 TPI (Not Shown) ............ 1
G0735 Flex-Shaft Rotary Tool (Figure 5)
G. Drill Bit
⁄ " .................................................. 1
1
8
H. Collet Chuck Wrench .................................. 1
I.
L-Wrench .................................................... 1
J.
Flex-Shaft Rotary Tool ................................ 1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0734/G0735 (Mfd. Since 12/15)
Qty
Figure 4. Box 1 inventory items.
H
Figure 5. Additional inventory items for G0735.
A
B
C
D
E
J
I
G
-13-