Table of Contents
Advertisement
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 26.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools away from machine.
2.
Make sure the blade is properly installed and
tensioned, and that the blade guard is in the
down position.
3.
Rotate the variable speed knob counterclock-
wise to 550 SPM.
4.
Connect the machine to the power source.
Model G0734/G0735 (Mfd. Since 12/15)
5.
Model G0735 Only: Firmly hold the flex-shaft
rotary tool.
6.
Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
7.
Remove the switch disabling key, as shown
in Figure 17.
Figure 17. Removing switch key from toggle
switch.
8.
Try to start the machine with the switch. The
machine should not start.
—If the machine does not start, the switch
disabling feature is working as designed.
—If the machine does start, immediately stop
the machine. The switch disabling feature
is not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
9.
Model G0735 Only: Remove the flex-shaft
rotary tool until you need to operate it, and
re-install the flex shaft cap.
-17-
Advertisement
Table of Contents
