Assembly; Scroll Saw Assembly - Grizzly G0734 Owner's Manual

Assembly

Scroll Saw Assembly

1.
ENSURE MACHINE IS DISCONNECTED
FROM POWER SUPPLY!
2.
Use the pre-installed Phillips head screw, hex
nut and washers to attach the blade guard to
the top of the hold-down shoe rod, as shown
in Figure 9. Avoid over-tightening screw!
Rod
Figure 9. Blade guard installed.
Note: Over-tightening the mounting screw
could crack the plastic arms of the blade
guard.
3.
Pivot the guard up and down to ensure
it moves smoothly. If necessary, loosen
the mounting screw until the guard moves
smoothly.
4.
Connect the air tubing to the backside of the
air nozzle, as shown in Figure 10.
Air Tubing
Connection
Figure 10. Air tubing connections.
Model G0734/G0735 (Mfd. Since 12/15)
5.
6.
7.
8.
Air Tubing
Connection
Check that the blade pins are seated in the
V-notch indents, as shown in Figure 27 and
Figure 28 on Page 23.
Pinch the blade and move it side to side with
light pressure to verify that it is tensioned
enough that it will not come off during opera-
tion. Blade tensioning instructions are provid-
ed on Page 20, if adjustments are necessary.
Fit a shop vacuum hose over the dust port
(Figure 11) and secure it in place with a hose
clamp.
1 ⁄ " OD
1
2
Dust Port
Figure 11. Dust port.
Tug the hose to make sure it does not come
off. A tight fit is necessary for proper perfor-
mance.
-15-