Draining The Front Brake Circuit - PEUGEOT Satelis 500 Workshop Manual

Draining the front brake circuit.

- Remove the cover from the RH master
cylinder.
- Using the syringe, empty the RH master
cylinder.
- Position the handlebars so that the master
cylinder is in its uppermost position, in order
to expell the air bubbles from the circuit.
- Fill the syringe equippd with a transparent
pipe with brake fluid.
- Connect the syringe to the bleed screw of
the front calliper.
- Open the bleed screw by 1 to 2 turns.
- Inject the brake fluid slowly into the circuit
until the level inside the reservoir is halfway
up.
- Close the bleeder screw.
- Slowly actuate the brake control lever by
displacing it 2 cm (A) maximum from its rest
position until no more bubbles can be seen
coming up through the master cylinder.
- This operation can take a few minutes.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
SERVICING THE ABS/MBS SYSTEM
A
61