Installation - Siemens SIMOREG DC-MASTER Operating Instructions Manual

12.2010
5

Installation

CAUTION
Failure to lift the unit properly can lead to physical injury or material damage.
The unit should only be lifted with suitable equipment (work gloves should be used) and by
appropriately qualified personnel.
In order to prevent the enclosure from becoming deformed, no horizontal forces may be exerted
on the lifting eyes.
The user is responsible for installing the converter, the motor, the transformer as well as all of
the other devices and units according to the relevant safety regulations (e.g. EN, DIN, VDE) as
well as all of the other relevant national or local regulations regarding dimensioning conductors
and protection, grounding, disconnectors, overcurrent protection etc.
The unit must be installed in compliance with the relevant safety regulations (e.g. EN, DIN, VDE) as
well as all of the other relevant national or local regulations. Grounding, conductor dimensioning,
and the relevant short-circuit protection measures must be carried out correctly in order to ensure
operational safety.
Cabinet installation of SIMOREG units in conformance with UL 508 C
If this unit is to be installed in a cabinet, the cabinet must be sufficiently ventilated and of "Type 1"
in accordance with standard UL 508 C.
To install the unit, the cabinet must have minimum dimensions of 2200 mm x 600 mm x 600 mm
(H x W x D).
Siemens AG 6RX1700-0DD74
SIMOREG DC-MASTER Converter Commutation Protector Operating Instructions
Installation
21
ENGLISH