Table of Contents
Advertisement
Unit software version:
When these operating instructions went to print, SIMOREG CCP units were being supplied from the factory
with software release 1.2.
When using a SIMOREG DC-MASTER as basic converter unit:
The SIMOREG DC-MASTER must have software release 2.2 or higher.
The software release of the SIMOREG DC-MASTER can be read-out at parameters r060 and r065, the
software release of the associated SIMOREG CCP can be read-out at parameter n560.
When using a SINAMICS DCM as basic converter unit:
The SINAMICS DCM must have software release 1201400 or higher.
The software release of the SINAMICS DCM can be read-out at parameter r50060[6], the software
release of the associated SIMOREG CCP can be read-out at parameter r51560[0].
The latest software release for the SIMOREG CCP is available on the Internet page
http://support.automation.siemens.com/WW/view/de/19847387/133100
Transmission as well as duplication of this document, use and
communication of its content is not permitted unless expressly
authorized. Failure to observe this rule will lead to damage claims. All
rights, including rights created by patent grant or registration of a utility
model or design, are reserved.
© Siemens AG 2005 - 2010 All rights reserved
SIMOREG ® and SINAMICS ® are registered
trademarks of Siemens
12.2010
Hide quick links:
Advertisement
Table of Contents
