Replacing Light Bulbs - Toyota 2003 MR2 Spyder Owner's Manual

03 07.07
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle's paint.
226

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
D
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the wind-
shield fogged up in the rain. However, if
there is large drop of water on the inside
of the lens, or if there is water pooled
inside the light, contact your Toyota deal-
er.
if
2003 MR2 from Aug. '03 Prod. (OM17511U)