Toyota 2003 MR2 Spyder Owner's Manual page 109

03 07.07
CAUTION
D
Be careful when accelerating, up-
shifting, downshifting or braking on
a slippery surface. Sudden accelera-
tion or engine braking could cause
the vehicle to spin or skid.
D
To drive down a long or steep hill,
reduce your speed and downshift.
Remember, if you ride the brakes
excessively, they may overheat and
fail.
D
Do not place the selector lever in
the "N" position while
Otherwise the engine brake may not
work, and you may get involved in
an unexpected accident.
D
Do not apply the parking brake
while driving. Otherwise, it could
cause a skid and you may get in-
volved in an unexpected accident.
NOTICE
z The system will not allow shifting
up or down to a gear that would
cause engine over–revving or un-
der–revving. When engine over–rev-
ving occurs, a
(short pulse sound) will sound. In
either case, the demand will be can-
celled.
z If frequently driving at low speed
using a high gear position, a warn-
ing buzzer (long pulse sound) will
sound. Such driving will cause the
driving.
reduction of clutch life.
z Frequent downshifting (more than 3
positions continuously) causes the
reduction of transmission life.
z Do not drive with your foot on the
brake pedal. Otherwise, it will cause
the "Sequential
transmission" warning light to come
on.
(e) Starting off
1. Start the engine as instructed in "How
to start the engine" on page 154 in
Section 3.
2. With your foot holding down the brake
pedal, shift the selector lever to the "S"
position properly. When the selector le-
ver is shifted to "S" position, the gear
will be shifted to 1st. On a slippery
surface, it is possible to start off with
the gear in 2nd. To start off with the
warning buzzer
gear in 2nd, shift the selector lever
from "N" to "S" position, then operate
the lever to "+" direction. The gear will
be shifted to 2nd. Before starting off,
always make sure that the gear is en-
gaged by the gear position indicator,
then depress the accelerator pedal.
If the gear cannot be engaged to 1st
when the selector lever is shifted from
the "N" to "S" position, the "N" indica-
tor will flash and a warning buzzer
(long pulse sound) will sound. In this
case, the system will re–try shifting or
the driver can operate the selector le-
manual
ver to shift, as follows.
D
The system will re–try shifting automat-
ically. This will take some time, noise
may be heard from the gears, and shift
shock may occur. However, they do not
indicate malfunction.
D
The driver may shift the selector lever
to the "N" position once, then shift to
the "S" position.
2003 MR2 from Aug. '03 Prod. (OM17511U)
89