Toyota 2003 MR2 Spyder Owner's Manual page 274

03 07.07
Positioning the jack
SB71008
Front of vehicle
When jacking up your vehicle with the
jack, position the jack correctly as
shown in the illustration.
Jack position . . . . . . . . . . . . . . . . .
Front—Front crossmember
Rear—Rear engine mounting bracket
Support position and
Pantograph jack position . . . . .
204
CAUTION
When jacking, be sure to observe the
following to reduce the possibility of
personal injury:
D
Follow jacking instructions.
D
Do not put any part of your body
under the vehicle supported by a
jack. Personal injury may occur.
D
Do not start or run the engine while
your vehicle is supported by the
jack.
D
Stop the vehicle on a level firm
ground, firmly set the parking brake
and put the transmission in reverse.
Block the wheel diagonally opposite
to the one being changed if neces-
sary.
D
Make sure to set the jack properly
in the jack point. Raising the ve-
hicle with jack improperly
tioned will damage the vehicle or
may allow the vehicle to fall off the
jack and cause personal injury.
D
Never get under the vehicle when
the vehicle is supported by the jack
alone; use vehicle support stands.
D
Do not raise the vehicle with some-
one in the vehicle.
D
When raising the vehicle, do not
place any objects on top of or un-
derneath the jack.
NOTICE
Make sure to place the jack correctly,
or your vehicle may be damaged.
posi-
2003 MR2 from Aug. '03 Prod. (OM17511U)