Replacing Light Bulbs - Toyota COROLLA 2007 Owner's Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
Vehicles with rear spoiler—The
mounted stoplight consists of a number of
LEDs. If any of the LEDs burn out, take
your vehicle to your Toyota dealer to have
the light replaced.
CAUTION
D
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
272
'07 Corolla_U (L/O 0608)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
high
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
if
Light bulbs
Headlights
(high beam)
Headlights
like the
(low beam)
Parking/front side
marker/front turn
signal lights
contact your
Front fog lights
Rear side marker
and stop/tail lights
Rear turn signal
lights
Back−up lights
High mounted
stoplight
License plate lights
Interior light
2007MY COROLLA from Oct. '06 Prod. (OM12B32U)
Bulb
W Type
No.
65
9005 A
9006 55 B
3157A
27/8 C
55
9006 B
3157 27/8 D
3157A
27/8 C
921 18 D
921 18 D
— 5 D
—
8 E