Installing the Tape Drive
Figure 3.3 Attaching the SCSI cable
SCSI cable
1 Perform a normal system shutdown and turn off the computer and any
connected peripherals. Disconnect the power cable from the outlet.
2 Attach one end of the SCSI cable to one of the connectors on the back of
the tape drive (it does not matter which connector you use). Press the clips
on the sides of the connector as you attach it, then release the clips, making
sure that the cable is securely attached.
3 Attach the other end of the SCSI cable to your computer's external SCSI
connector.
4 Connect the power supply to the power connector on the back of the tape
drive as shown in figure 3.4.
Installing an External Tape Drive
Installing the Tape Drive
Tape drive
3-5