Installation Overview - HP surestore t20xe User Manual

Preparing for Installation
External Drives

Installation Overview

Check System
Prerequisites
Prepare
Tape Drive
Install
Tape Drive
Verify the
Installation
Install Backup
Software
Install Driver
Software
1-6
Installing the HP SureStore T20 tape drive is a simple procedure requiring
no special skills, providing that your system meets the prerequisites. The
hardware installation process should take about 15 minutes.


See "Checking System Prerequisites" on page 1-7.
•
Properly installed and configured SCSI
controller
•
CD-ROM drive to load software
•
High-density, 50-pin SCSI connector


See "Preparing the Tape Drive" on page 3-3.
•
Run TapeAssure (optional)
•
Check SCSI ID and reset if necessary


See "Installing the Tape Drive" on page 3-5.
•
Perform a normal system shutdown
•
Remove power cables
•
Attach SCSI cable
•
Attach power supply to tape drive
•
Attach power cord to power supply and plug
into outlet
•
Reconnect computer's power cables


See "Verifying the Installation" on page 3-7.
•
Switch on computer and boot up
•
Install TapeAssure from CD-ROM
•
Run TapeAssure and perform a test backup and
restore


See "Installing Backup Software" on page 3-8.
•
Install backup software from CD-ROM


See "Installing Driver Software" on page 3-8.
•
Install driver software from CD-ROM