Yamaha 2004 WR250FS Owner's Service Manual page 308

ELECTRIC STARTING SYSTEM
3
2
1
a
DIODE INSPECTION
1. Remove the diode from wire harness.
2. Inspect:
• Diode continuity
Use pocket tester
(tester selection position Ω × 1)
Tester (+) →
Blue/Red terminal 1
Tester (–) →
Sky blue terminal 2
Tester (+) →
Blue/Red terminal 1
Tester (–) →
Blue/Yellow terminal 3
Tester (+) →
Sky blue terminal 2
Tester (–) →
Blue/Red terminal 1
Tester (+) →
Blue/Yellow terminal 3
Tester (–) →
Blue/Red terminal 1
Incorrect continuity → Replace.
START SWITCH INSPECTION
1. Inspect:
• Start switch continuity
Tester (+) lead → Black lead 1
Tester (–) lead → Black lead 2
PUSH IN
FREE
No continuous while being pushed → Replace.
Continuous while being freed → Replace.
2. Inspect:
• Rubber part a
Tears/damage → Replace.
6 - 12
–
ELEC
Continuous
Continuous
No
continuous
No
continuous
Tester selector
B B
1 2
position
Ω × 1
+