Yamaha 2004 WR250FS Owner's Service Manual page 236

FRONT WHEEL AND REAR WHEEL
1
11. Install:
• Trip meter cable 1
Rear wheel
1. Install:
• Bearing (right) 1
• Circlip 2
New
• Spacer 3
• Bearing (left) 4
• Oil seal 5
NOTE:
• Apply the lithium soap base grease on the
bearing and oil seal lip when installing.
• Install the bearing with seal facing outward.
• Use a socket that matches the outside diam-
eter of the race of the bearing.
• Right side of bearing shall be installed first.
• Install the oil seal with its manufacture's
marks or numbers facing outward.
CAUTION:
Do not strike the inner race of the bearing.
Contact should be made only with the outer
race.
2. Install:
• Brake disc 1
• Bolt (brake disc) 2
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
5 - 8
CHAS
New
14 Nm (1.4 m · kg, 10 ft · lb)