Yamaha 2004 WR250FS Owner's Service Manual page 247

FRONT BRAKE AND REAR BRAKE
5 - 19
2. Install:
• Copper washer 1
• Union bolt 2
30 Nm (3.0 m · kg, 22 ft · lb)
WARNING
Always use new copper washers.
CAUTION:
Install the brake hose so that its pipe por-
tion a directs as shown and lightly
touches the projection b on the brake cali-
per.
3. Install:
• Brake hose holder 1
• Brake caliper 2
• Bolt (brake caliper) 3
23 Nm (2.3 m · kg, 17 ft · lb)
NOTE:
Fit the brake hose holder cut a over the pro-
jection b on the front fork and clamp the brake
hose.
4. Tighten:
• Pad pin 4
18 Nm (1.8 m · kg, 13 ft · lb)
5. Install:
• Pad pin plug 5
3 Nm (0.3 m · kg, 2.2 ft · lb)
Rear brake caliper
1. Install:
• Pad support 1
• Brake pad 2
• Pad pin 3
NOTE:
• Install the brake pads with their projections
a into the brake caliper recesses b.
• Temporarily tighten the pad pin at this point.
CHAS
New