Yamaha 2004 WR250FS Owner's Service Manual page 251

FRONT BRAKE AND REAR BRAKE
5 - 23
4. Install:
• Pin 1
• Washer 2
• Cotter pin 3
New
NOTE:
After installing, check the brake pedal height.
Refer to "REAR BRAKE ADJUSTMENT" sec-
tion in the CHAPTER 3.
Front brake hose
1. Install:
• Brake hose 1
10 Nm (1.0 m · kg, 7.2 ft · lb)
To brake hose holder 2.
NOTE:
Before tightening the bolt (brake hose holder),
align the top a of the brake hose neck with the
brake hose holder bottom b. Then pass the
brake hose in front of the axle boss c and fit it
into the hose groove d so that the brake hose
does not contact the nut (wheel axle).
2. Install:
• Brake hose cover 1
• Washer 2
• Bolt [brake hose cover (M8)] 3
16 Nm (1.6 m · kg, 11 ft · lb)
• Bolt [brake hose cover (M6)] 4
7 Nm (0.7 m · kg, 5.1 ft · lb)
3. Pass the brake hose through the front
brake hose guide 1, then through the
guide a on the protector 2.
CHAS