Yamaha 2004 WR250FS Owner's Service Manual page 206

AC MAGNETO AND STARTER CLUTCH
1
E
3
1
2
a
2
1
c
5. Install:
2
NOTE:
Apply the engine oil on the washer, bearing
and starter clutch drive gear inner circumfer-
ence.
6. Install:
a
NOTE:
• Install the starter clutch with its plate side
• While installing the starter clutch, push in the
• Push in the starter clutch until it hits the rotor.
7. Install:
1
NOTE:
b Install the starter clutch assembly cover by fit-
ting its pawls a into the groove b in the rotor.
8. Install:
1
a b
NOTE:
• Clean the tapered portions of the crankshaft
• When installing the woodruff key, make sure
2
• When installing the rotor, align the keyway c
4 - 84
• Washer 1
• Bearing 2
• Starter clutch drive gear 3
• Starter clutch 1
To rotor 2.
upward.
projections a one by one on the clutch cir-
cumference.
• Starter clutch assembly cover 1
To rotor 2.
• Woodruff key 1
• Rotor 2
and rotor.
that its flat surface a is in parallel with the
crankshaft center line b.
of the rotor with the woodruff key.
ENG