Honeywell IAQPoint2 User Manual page 1330

Introduction
Installation Instructions
Special Duct-mount Installation
The IAQPoint must be duct mounted using a special box if it is equipped
with the temperature and humidity sensor "antenna". All of the
components housed within the box are factory assembled.
Housing cover
1. Select the location for the unit
2. Measure and mark the holes for intake and exhaust tubes
3. Drill the holes for the sampling tubes.
4. Affix intake and exhaust tubes to mounting box
5. Insert the tubes into the holes in conduit, orienting the air holes on the
air intake tube to face the airflow.
6. Screw the mounting box onto the conduit.
7. Remove the desired knock out (depending on where cables will enter
box) and affix appropriate conduit.
8. Remove the IAQPoint from the mounting plate to access connection
terminals
9. Run wiring through conduit and electrical box to unit and connect
wires according to Wiring Details
10. Press the IAQPoint onto the plastic base (latches will click).
14
Air flow
Air intake tube
Ductmount housing
IAQPoint User Manual
Air exhaust tube