How To Turn The Power On Or Off - Furuno TZTL12F Operator's Manual

* When you switch the steering mode with the STBY•AUTO key, a beep sounds and
then one of the messages shown below appears. The message does not appear on
the home screen. STBY modeAUTO mode: "NAVpilot is engaged."
AUTO modeSTBY mode: "NAVpilot is disengaged."
1.3

How to Turn the Power On or Off

The Power switch (
When you turn on the power, the equipment beeps twice and the start-up screen ap-
pears. After the startup process is completed, the [NAVIGATION WARNING] screen
appears. Read the warning, then tap [OK]. Then, the last-used display appears.
The color of the lamp in the power switch changes according to equipment state.
Green: Equipment is powered.
Orange: Equipment is not powered but power is flowing to the equipment.
To turn off the power, tap the power switch to show the [Power & Brilliance] window.
Tap [Power Off This Equipment] or [Power Off Network], then tap [OK].15 seconds af-
ter the screen goes blank, the power turns off. (The power is on for this 15 seconds.)
Note 1: If you cannot turn off the power as shown above or the display freezes, long
push the power switch until the screen goes blank.
) on the front panel controls the power.
1. SYSTEM INTRODUCTION
Power
switch
Closes the
window.
Tap either of
these two.
1-7