Copying A Destination Profile - Cisco Catalyst 4500 Series Configuration Manual

Configuring Call Home
Command
Step 5
Switch(cfg-call-home-profile)#
destination address {email
email-address | http url}
Step 6
Switch(cfg-call-home-profile)#
destination preferred-msg-format
{long-text | short-text | xml}
Step 7
Switch(cfg-call-home-profile)#
destination message-size-limit bytes
Step 8
Switch(cfg-call-home-profile)#
active
Step 9
Switch(cfg-call-home-profile)# exit
Step 10
Switch(cfg-call-home)# end
Step 11
Switch# show call-home profile {name
| all}

Copying a Destination Profile

To create a new destination profile by copying an existing profile, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# call-home
Step 3
Switch(cfg-call-home)# copy profile
source-profile target-profile
Subscribing to Alert Groups
An alert group is a predefined subset of Call Home alerts supported on the switch. Different types of Call
Home alerts are grouped into different alert groups depending on their type. These alert groups are
available:
•
•
•
•
•
The triggering events for each alert group are listed in the
section on page
section on page
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
65-6
Configuration
Diagnostic
Environment
Inventory
Syslog
65-18, and the contents of the alert group messages are listed in the
65-21.
Purpose
Configures the destination e-mail address or URL to which
Call Home messages will be sent.
Note When entering a destination URL, include either
http:// or https://, depending on whether the server
is a secure server. If the destination is a secure
server, you must also configure a trustpoint CA.
(Optional) Configures a preferred message format. The
default is XML.
(Optional) Configures a maximum destination message size
for the destination profile.
Enables the destination profile. By default, the profile is
enabled when it is created.
Exits the Call Home destination profile configuration
submode and returns to the Call Home configuration
submode.
Returns to privileged EXEC mode.
Displays the destination profile configuration for a
specified profile or all configured profiles.
Purpose
Enters configuration mode.
Enters the Call Home configuration submode.
Creates a new destination profile with the same
configuration settings as the existing destination
profile.
"Alert Group Trigger Events and Commands"
Chapter 65 Configuring Call Home
"Message Contents"
OL-25340-01