Enabling and Configuring Ethernet OAM
Command
Step 6
Switch(config-if)# ethernet oam link-monitor
{
frame-period
} |
{
none
low
low-frames
Repeat this step to configure both high and low
thresholds.
Step 7
Switch(config-if)# ethernet oam link-monitor
frame-seconds
} |
{
none
low
low-frames
Repeat this step to configure both high and low
thresholds.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
63-40
{
{
threshold
high
high-frames
}} |
window frames
{
{
{
threshold
high
high-frames
}} |
window milliseconds
Purpose
(Optional) Configures high and low thresholds for the
|
error-frame period that triggers an error-frame-period link
}
event.
•
Enter threshold high high-frames to set a high
threshold in number of frames. The range is 1 to
65535. The default is none.
Enter threshold high none to disable the high
•
threshold if it was set. it is the default.
Enter threshold low low-frames to set a low threshold
•
in number of frames. The range is 0 to 65535. The
default is 1.
•
Enter window frames to set the a polling window size
in number of frames. The range is 1 to 65535; each
value is a multiple of 10000 frames. The default is
1000.
(Optional) Configures high and low thresholds for the
|
frame-seconds error that triggers an error-frame-seconds
}
link event.
Enter threshold high high-frames to set a high error
•
frame-seconds threshold in number of seconds. The
range is 1 to 900. The default is none.
Enter threshold high none to disable the high
•
threshold if it was set. it is the default.
•
Enter threshold low low-frames to set a low threshold
in number of frames. The range is 1 to 900. The default
is 1.
•
Enter window frames to set the a polling window size
in number of milliseconds. The range is 100 to 9000;
each value is a multiple of 100 milliseconds. The
default is 1000.
Chapter 63
Configuring Ethernet OAM and CFM
OL-25340-01