Configuring Ip Slas Cfm Operation - Cisco Catalyst 4500 Series Configuration Manual

Configuring Ethernet CFM
Command
Step 10
end
Step 11
show running-config
Step 12
copy running-config startup-config
Use the no form of each command to remove a configuration or to return to the default settings.
The following example illustrates how to configure Ethernet CFM fault alarms:
Switch(config)# ethernet cfm alarm notification remote-error-xcon
Switch(config)# ethernet cfm logging alarm ieee
Switch(config)# interface gigabitethernet1/2
Switch(config-if)# ethernet cfm mep domain abc mpid 222 vlan 5
Switch(config-if-ecfm-mep)# alarm notification mac-remote-error-xcon
Switch(config-if)# end

Configuring IP SLAs CFM Operation

You can manually configure an IP SLA's Ethernet ping or jitter echo operation, or you can configure
IP SLAs Ethernet operation with endpoint discovery. You can also configure multiple operation
scheduling. For accurate one-way delay statistics, the clocks on the endpoint switches must be
synchronized. You can configure the endpoint switches with Network Time Protocol (NTP) so that the
switches are synchronized to the same clock source.
For detailed information about configuring IP SLAs Ethernet operations, see the Cisco IOS IP SLAs for
Metro-Ethernet feature module at this URL:
http://www.cisco.com/en/US/docs/ios-xml/ios/ipsla/configuration/15-1s/Configuring_Cisco_IOS_IP_S
LAs_for_Metro-Ethernet.html
and
http://www.cisco.com/en/US/docs/ios-xml/ios/ipsla/configuration/xe-2/Configuring_IP_SLAs_for_Me
tro-Ethernet.html
For detailed information about IP SLAs operations, see the Cisco IOS IP SLAs Configuration Guide,
Release 12.4T at this URL:
http://www.cisco.com/en/US/products/ps6441/products_installation_and_configuration_guides_list.ht
ml
For detailed information about IP SLAs commands, see the command reference at this URL:
http://www.cisco.com/en/US/docs/ios/ipsla/command/reference/sla_book.html
This section includes these procedures:
•
•
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
63-18
Manually Configuring an IP SLAs CFM Probe or Jitter Operation, page 63-19
Configuring an IP SLAs Operation with Endpoint Discovery, page 63-21
Chapter 63
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Configuring Ethernet OAM and CFM
OL-25340-01