Displaying Rmon Status - Cisco Catalyst 4500 Series Configuration Manual

Displaying RMON Status

Command
Step 6
Switch# show rmon history
Step 7
Switch# copy running-config startup-config
To collect group Ethernet statistics on an interface, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface interface-id
Step 3
Switch(config-if)# rmon collection stats
[
index owner ownername
Step 4
Switch(config-if)# end
Step 5
Switch# show running-config
Step 6
Switch# show rmon statistics
Step 7
Switch# copy running-config startup-config
Displaying RMON Status
To display the RMON status, use one or more of the following privileged EXEC commands:
Command
show rmon
show rmon alarms
show rmon events
show rmon history
show rmon statistics
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
67-6
]
Purpose
Displays the contents of the switch history table.
(Optional) Saves your entries in the configuration file.
Purpose
Enters global configuration mode.
Specifies the interface on which to collect statistics, and enter
interface configuration mode.
Enables RMON statistic collection on the interface.
For index, specify the RMON group of statistics. The range
•
is from 1 to 65535.
(Optional) For owner ownername, enter the name of the
•
owner of the RMON group of statistics.
To disable the collection of group Ethernet statistics, use the no
rmon collection stats index interface configuration command.
Returns to privileged EXEC mode.
Verifies your entries.
Displays the contents of the switch statistics table.
(Optional) Saves your entries in the configuration file.
Purpose
Displays general RMON statistics.
Displays the RMON alarm table.
Displays the RMON event table.
Displays the RMON history table.
Displays the RMON statistics table.
Chapter 67 Configuring RMON
OL-25340-01