Power-On Self-Test Diagnostics - Cisco Catalyst 4500 Series Configuration Manual

The message indicates that the line card passed online diagnostics either when it was inserted into the
chassis the last time or when the switch was powered up (as reported by the "."). You need to obtain
additional information to determine the cause.
Step 2 Insert a different supervisor engine card and reinsert the line card.
If the line card passes the test, it suggests that the supervisor engine card is defective.
Issue an RMA for the supervisor engine, contact TAC, and skip step 3.
Because online diagnostics are not run on the supervisor engine card, you cannot use the
#show diagnostic module 1 command to test whether the supervisor engine card is faulty.
Step 3 Reinsert the line card in a different chassis.
If the line card passes the test, the problem is associated with the chassis.
Issue an RMA for the chassis and contact TAC.

Power-On Self-Test Diagnostics

The following topics are discussed:
•
•
•
•
Overview of Power-On Self-Test Diagnostics
All Catalyst 4500 series switches have power-on self-test (POST) diagnostics that run whenever a
supervisor engine boots. POST tests the basic hardware functionality for the supervisor switching
engine, its associated packet memory and other on-board hardware components. The results of the POST
impacts how the switch boots, because the health of the supervisor engine is critical to the operation of
the switch. The switch might boot in a marginal or faulty state.
POST is currently supported on the following supervisor engines:
•
•
•
•
•
•
•
•
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
68-10
Overview of Power-On Self-Test Diagnostics, page 68-10
POST Result Example, page 68-11
Power-On Self-Test Results, page 68-13
Troubleshooting the Test Failures, page 68-20
WS-X4014
WS-X4515
WS-X4516
WS-X4516-10GE
WS-X4013+
WS-X4013+TS
WS-X4013+10GE
WS-C4948G
Chapter 68 Performing Diagnostics
OL-25340-01