Step 5: Connect Power To The Acx Series Router; Connect Ac Power To An Ac-Powered Acx1100 Router - Juniper ACX1100 Quick Start Manual

ACX1000 and ACX1100 Universal Access Routers Quick Start

Step 5: Connect Power to the ACX Series Router

Connect AC Power to an AC-Powered ACX1100 Router

14
Depending on your configuration, your router uses either AC or DC power supplies. Perform
the appropriate procedures for each power supply in your router.
WARNING: You must ground the router before connecting the power cables.
Connect AC Power to an AC-Powered ACX1100 Router on page 14
Connect DC Power to a DC-Powered ACX1000 or ACX1100 Router on page 15
To connect power to the AC-powered router, you need the following tools:
AC power cords
Locate power cords that have a plug appropriate for your geographical location. For
1.
more information, see the
.
Guide
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Insert the appliance coupler end of the power cord into the appliance inlet on the
3.
power supply.
Insert the power cord plug into an external AC power source receptacle.
4.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated customer site circuit breaker. We recommend that
you use a dedicated customer site circuit breaker rated for 2 A (100 VAC)
minimum or 1 A (240 VAC), or as required by local code.
Dress the power cord appropriately. Verify that the power cord does not block the air
5.
exhaust and access to router components, or drape where people could trip on it.
Repeat Step 1 through Step
6.
Observe the system LED on the router. If an AC power supply is functioning normally,
7.
the system LED lights green steadily.
If the system LED is not lit, the power supply is not functioning normally. Repeat the
cabling procedures.
ACX1000 and ACX1100 Universal Access Routers Hardware
5 for the remaining power supply.
Copyright © 2015, Juniper Networks, Inc.