Table 4-19 Procedure For Displaying Alarm Setpoints - Honeywell UDC3200 Product Manual

Alarm Setpoints Display

Table 4-19 Procedure for Displaying Alarm Setpoints

Step Operation
Select Alarm
1
Set-up Group
2 Access the Alarm
Setpoint Values
3 Change a value
4 Return to Normal
Display
12/04
Press
Until you see:
Setup Setup
Upper Display = SET
Lower Display = ALARMS
To successively display the alarm setpoints and their values.
Function Function Function
Their order of appearance is shown below.
Upper Display = (the alarm setpoint value)
Range values are within the range of the selected
parameters except:
DEVIATION (DEV) value = PV Span
EVENTS (EV-ON/EV-OFF) value = Event Segment Number
PV RATE OF CHANGE (PVRATE) = The amount of PV
change in one minute in engineering units.
LOOP BREAK ALARMS (BREAK) = The timer value may
be changed only for controllers configured for ON/OFF
control.
Lower Display = A1S1 VAL = Alarm 1, Setpoint 1 Value
NOTES:
With Three position step control, alarms set for "output" will
not function.
MANUAL, RSP, and F'SAFE selections do not have setpoint
values.
To change any alarm setpoint value in the upper display.
or
Lower Lower Lower
Display Display Display
UDC3200 Universal Digital Controller Product Manual
Monitoring and Operating the Controller
Result
A1S2 VAL = Alarm 1, Setpoint 2 Value
A2S1 VAL = Alarm 2, Setpoint 1 Value
A2S2 VAL = Alarm 2, Setpoint 2 Value
119