Replacing The Compactflash Card - Siemens SIMOTION D410-2DP/PN Installation Manual

Service and maintenance
8.2 Replacing modules
3) Locate the centering frame of the replacement fan on the
mounting lug of the SIMOTION D410-2.
8.2.5

Replacing the CompactFlash card

If spare parts are used, you must contact the Technical Support Center to transfer the license
key of the defective CompactFlash card to the new CompactFlash card.
Proceed as follows to write your project to the new CompactFlash card:
● Changing the CompactFlash card (Page 291)
● Writing to a CompactFlash card (Page 292)
Detailed information about licensing can be found:
● In the
● In the FAQs on the Internet
36947932)
268
SIMOTION SCOUT Configuration Manual
(http://support.automation.siemens.com/WW/view/en/
4) Slide the replacement fan on the mounting lug into the
Control Unit.
Make sure that the fan connector fits into the centering frame
of the the printed circuit board.
Engage both snap hooks on the fan in the housing of the
Control Unit.
Commissioning and Hardware Installation Manual, 01/2015
SIMOTION D410-2