Siemens sinumerik 840d Programming Manual page 65

04.00
1
840D 840D
NCU 571 NCU 572
NCU 573
WAITMC(Marker No., n, n, ...)
WAITE (n,n)
SETM(Marker No., Marker No., ...)
CLEARM(Marker No., Marker No., ...)
Note
All the above commands must be programmed
in separate blocks.
Channel names
Channel names must be converted to numbers
via variables (see Section 10 "Variables and
Arithmetic Parameters").
Protect the number assignments so that they
are not changed unintentionally.
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
FM-NC 810D 840Di
Flexible NC programming
1.13 Program coordination
Sets the marker "Marker No." in the same
channel. An exact stop is initiated only if the
other channels have not yet reached the
marker. Waits for the marker with the same
"Marker no." in the specified channels "n"
(current channel does not have to be
specified). As soon as marker "Marker N" in
the specified channels is reached, continue
without terminating exact stop.
Waits for the end of program of the specified
channels (current channel not specified)
Sets the markers "Marker No." in the same
channel without affecting current processing.
SETM() remains valid after RESET and NC
START. SETM() can also be programmed
independently of a synchronized action.
Deletes the markers "Marker No." in the same
channel without affecting current processing.
All markers can be deleted with CLEARM().
CLEARM (0) deletes the marker "0".
CLEARM() remains valid after RESET and
NC START. CLEARM() can also be
programmed independently of a synchronized
action.
1
1-65