Siemens sinumerik 840d Programming Manual page 588

Appendix
A
Index
String operations 1-46
Subprogram call
Indirect 1-37
Subprogram call, search path 3-127
Subprogram run with path specification 2-106
Subprogram with path specification and
parameters 2-106
Subprogram, external 2-111
Subprograms 2-92
Indirect subprogram call 2-105
Modal subprogram call 2-104
Nesting 2-93
Program repetition 2-103
SAVE mechanism 2-94
Subprogram call 2-99
Subprogram with parameter transfer 2-99
Subprograms with parameter transfer
Array definition 2-98
Parameter transfer between main program and
subprogram 2-95
Supplementary conditions 1-61, 5-171, 10-391
Supplementary conditions with
transformations 7-251
SW limit switch 10-377
Switchable geometry axes 7-257
Synchronization run
Coarse 13-431
Fine 13-431
Setpoint synchronization 13-431
Synchronized action 13-454
Synchronized action parameters 10-354
Synchronized actions
Static 9-323
Synchronized oscillation
Assignment of oscillating and infeed
axes 11-405
Definition of infeed 11-405
Infeed in reversal area 11-407
Stop at reversal point 11-409
Synchronized action 11-406
Synchronized spindle 13-431
Activate synchronized mode 13-437
Block change behavior 13-436
Coupling type 13-436
A-588
Deactivate synchronized mode 13-437
Define pair 13-433
Delete coupling 13-438
Pair 13-432
Speed ratio 13-435
System variables 1-23
System variable 1-22
System variables 13-454
Global 13-454
T
TANG 9-303
Tangential control
Angle limit through working area
limitation 9-304
Defining following axis and leading axis 9-303
Tangential control, activation, TANGON 9-304
Tangential control, deactivation 9-304
Technology cycles 10-386
Thread blocks 5-171
Three-digit M/G function 2-119
Timer variable 10-353
Tool management 8-266
Tool monitoring, grinding-specific 8-271
Tool offset
3D face milling 8-281
Offset memory 8-264
Online 8-269
Tool offsets
Face milling 8-278
Tool orientation 7-223, 8-286
With LEAD and TILT 7-227
Tool radius compensation, 3D 8-278
Behavior at outside corners 8-287
Circumferential milling 8-280, 8-281
Insertion depth (ISD) 8-284
Inside corners/outside corners 8-284
Programming tool orientation 8-286
Tool orientation 8-286
Toolholder 8-297
Clear/edit/read data 8-298
Kinematics 8-296
Torsion 13-429
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
04.00
A
 Siemens AG 2000. All rights reserved