Oscillation Controlled Via Synchronized Actions - Siemens sinumerik 840d Programming Manual

08.97
11
840D 840D
NCU 571 NCU 572
NCU 573
11.2

Oscillation controlled via synchronized actions

Programming
1. Define parameters for oscillation
2. Define motion-synchronized actions
3. Assign axes, define infeed
Parameters for oscillation
OSP1[oscillating axis]=
OSP2[oscillating axis]=
OST1[oscillating axis]=
OST2[oscillating axis]=
FA[OscillationAxis]=
OSCTRL[OscillationAxis]=
OSNSC[oscillating axis]=
OSE[OscillationAxis]=
WAITP(OscillationAxis)
Axis assignment, infeed
OSCILL[OscillationAxis] = (InfeedAxis1, InfeedAxis2, InfeedAxis3)
POSP[InfeedAxis] = (Endpos, Partial length, Mode)
OSCILL
POSP
Endpos
Partial length
Mode
Motion-synchronized actions
WHEN... ... DO
WHENEVER ... DO
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
11.2 Oscillation controlled via synchronized actions
FM-NC 810D 840Di
Position of reversal point 1
Position of reversal point 2
Stopping time at reversal point 1 in seconds
Stopping time at reversal point 2 in seconds
Feed for oscillating axis
Set or reset options
Number of spark-out strokes
End position
Enable axis for oscillation
Assign infeed axis or axes for oscillating axis
Define complete and partial infeeds (see Chapter 3)
End position for the infeed axis after all partial infeeds have
been traversed.
Length of the partial infeed at reversal point/reversal area
Division of the complete infeed into partial infeeds
0 = Two residual steps of equal size (default);
1 = All partial infeeds of equal size
when ... , do
whenever ... , do
Oscillation
11
11-403