Online Tool Offset Putftocf, Putftoc, Ftocon, Ftocof - Siemens sinumerik 840d Programming Manual

04.00
8

8.3 Online tool offset PUTFTOCF, PUTFTOC, FTOCON, FTOCOF

840D
NCU 572
NCU 573
8.3 Online tool offset PUTFTOCF, PUTFTOC, FTOCON, FTOCOF
Programming
FCTDEF(Polynomial no., LLimit, ULimit,a
PUTFTOCF(Polynomial No., Ref_value, Length1_2_3, Channel, Spindle)
PUTFTOC(Value, Length1_2_3, Channel, Spindle)
FTOCON
Explanation of the commands
PUTFTOCF
FCTDEF
PUTFTOC
FTOCON
FTOCOF
Explanation of the parameters
Polynomial_No.
Ref_value
Length1_2_3
Channel
Spindle
LLimit
ULimit
a ,a ,a ,a
0 1 2 3
Value
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
840Di
Write online tool offsets continuously
Define parameters for PUTFTOCF function
Write online tool offsets discretely
Activate online tool offsets
Deactivate online tool offsets
Values 1−3: a maximum of three polynomials can be programmed at
the same time; polynomials up to 3rd degree
Reference value from which the offset is derived
Wear parameter into which the tool offset value is added
Number of channel in which the tool offset is activated; specified only if
the channel is different to the present one
Number of the spindle on which the online tool offset acts; only needs to
be specified for inactive grinding wheels
Lower limit
Upper limit
Coefficients of polynomial function
Value added in the wear parameter
,a ,a ,a )
0 1 2 3
Tool Offsets
8
8-269