Tangential Control Tang, Tangon, Tangof - Siemens sinumerik 840d Programming Manual

Path Traversing Behavior
9

9.1 Tangential control TANG, TANGON, TANGOF

840D
NCU 572
NCU 573
9.1 Tangential control TANG, TANGON, TANGOF
Programming
TANG (FAxisF,LAxis1,LAxis2,Coupling,CS)
TANGON (FAxis,Angle)
TANGOF (FAxis)
TLIFT (FAxis)
Explanation of the commands
TANG
TANGON
TANGOF
TLIFT
Explanation of the parameters
FAxis
LAxis1, LAxis2
Coupling
CSCS
Angle
9-302
810D 840Di
Preparatory instruction for the definition of a tangential follow-up
Activate tangential control specifying following axis and offset angle
Deactivate tangential control specifying following axis
Insert intermediate block at contour corners
Following axis: additional tangential following rotary axis
Leading axes: path axes which determine the tangent for the following axis
Coupling factor: relationship between the angle change of the tangent
and the following axis.
Parameter optional; default: 1
Identifier for coordinate system
"B" = basic coordinate system; "W" = workpiece coordinate system
Parameter optional; default "B"
Offset angle of following axis
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
08.97
9
 Siemens AG 2000. All rights reserved