Siemens sinumerik 840d Programming Manual page 518

Tables
15
15.2 List of system variables
Identifier Type
$TC_DP23 REAL
$TC_DP24 REAL
REAL
$TC_DP25
INT
$TC_DPCE
$TC_DPH INT
15-518
Description: System variable/value range/index
$TC_DP23[t,d]
Base – Length 3
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP23[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP24[t,d]
Clearance angle
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP24[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP25[t,d]
Reserved
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP25[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DPCE[t,d] = 'Cutting edge number' of offset data block t,d
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPCE[d]
CE stands for <C>utting<E>dge
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DPH[t,d] = 'H cutting edge number' of offset data block t,d for
Fanuc0 M
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPH[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
04.00
15
Part pro Sync O S
R W 2
R W 2
R W 4
R W 5
R W 5
.
1
 Siemens AG 2000. All rights reserved