Updating Firmware Version (1) - Pentax K100D Service Manual

(6) Turn the main switch to OFF.
(7) Insert the SD card for FW version-check [OFF] into the camera.
(8) Turn the main switch to ON while SD card cover is opened. Access lamp will blink for about 3
seconds.
(9) After the access lamp is disappeared, turn the main switch to OFF and remove the SD card
from the camera.
(10) Turn the main switch to ON while pressing MENU button. Confirm that the firmware
version is displayed on the LCD monitor as VER: x. x x If not, repeat a cancellation.

2. Updating Firmware Version (1)

[Required equipment]
Latest product Firmware for service (SD Card),
AC adaptor, fully charged battery.
[CAUTION] 1. If power is shut down during updating firmware,
electric part in the camera will be damaged.
2. When executing this updating, the camera will be
set default setting. (Menu, Custom function,
Language, Date / Time)
(1) Install the battery and connect the AC adaptor to the camera.
Then turn the main switch to OFF.
(2) Insert the SD card into the camera.
(3) The SD card cover must open until installation is completed.
(4) Turn the main switch to ON.
(5) FW version (CPU, DSP) will be appeared on the LCD monitor as shown in the figure.
If you cancel the updating, disconnect the all power at this point.
(6) Remove the SD card when the message [>>> EJECT SD CARD <<<] is appeared then starting
updating. (It takes approx 60sec for loading firmware)
[CAUTION] Do not turn OFF the camera while loading.
(7) Turn the main switch to OFF when the following message [POWER OFF] is appeared.
(Updating is completed)
(8) Insert the SD card into the camera again then
turn on the power condition with opening SD
card cover.
(9) Confirm that the latest version is displayed on
CURRENT version. (Example: VER.1.00.00.15)
(10) Remove battery and disconnect AC adapter
without removing the SD card.
(11) At the last remove the SD card.
76700 -80/94-
DETECTED BOTH F/W FILE
NOW LOADING
DETECTED FIRMWARE FILE
COMPLETE LOADING
------- CPU --------
CURRENT VER.1.00.00.00
UPDATE VER.1.00.00.10
======= DSP ========
CURRENT VER.1.00.00.00
UPDATE VER.1.00.00.10
>>> EJECT SD CARD <<<
PENTAX K100D
UPDATING DSP FIRMWARE
SECTOR** >> PROGRAM
_____________
PENTAX K100D
UPDATING DSP FIRMWARE
NEVER POWER OFF
**** COMPLETE ****
VERSION 1.00.00.10
POWER OFF