DISASSEMBLY AND ASSEMBLY PROCEDURES
Disassembly procedure of main body
[Preparation] Remove the Hot shoe cover FK, Eye cap FL and Battery from the main body.
1. POP-up the built-in flash
For removing top cover, install the batteries to the camera and turn on the camera then pop-up the flash by
pressing pop-up button.
*If the camera does not pop-up the flash: Use flash pop-up tool as shown in figure 1.
(The same tool as MZ-7) --- Use telephone card and processes it as follow
Fig. 1
3
2
1
② Remove A73 (TY screw x2
4.5mm)
②
2. A401 (Bottom cover)
① Unscrew A73 (TY screw x3 4.5mm)
② Unscrew A67 (screw x3 5mm)
③ Unscrew A75 (screw 1.7x1.8)
③
②
④ Open the battery cover and then remove
the battery cover and bottom cover.
⑤ Unhook A167 (spring)
⑤
※
①
④
[Caution]
There is strong magnet in the CCD/SR blocks therefore please do not place a screw or magnetic card near the
camera after the outside cover is removed.
76700 -9/94-