Disassemby And Assenbly; Caution; Flow For Assembly, Adjustment And Confirmation - Pentax K100D Service Manual

DISASSEMBLY AND ASSEMBLY
Outline of Disassembly and Assembly

1. Caution

(1) Be sure to use the anti-static mat and wrist strap to prevent static failure of circuits.
(2) This product is used lead free solder.
surface of solder will be white-tinged color. Solder quickly, because melting temperature is high and so if
heat to much, it is possible to damage to PC board.
Soldering iron requirement: The temperature can be adjusted up to 400º and exclusive use for lead free solder.
Also it is desirable to use antistatic soldering iron.
The temperature for tip of soldering iron must set between 340º ~ 360º for lead free solder.
(3) Do not stress to the connector terminals and flexible boards because they are very delicate parts.
Pay careful attention to the connector terminals and flexible boards and, we recommend marking to the
flexible board before disconnecting them. This will be helpful to reconnect the flexible board to the
connector terminal properly.
2. Flowchart for Assemble, Adjustment and Confirmation
2. ASSEMBLY AND DISASSEMBLY PROCEDURE OF FRONT HOUSING.................
(1) FRONT HOUSING BLOCK.......................................................................................
(2) 0-G100...........................................................................................................................
(3) M1.........................................................................................................................
(4) [CONFIRM] CHECKING THE MIRROR FUNCTION................................................
(5) A104............................................................................................................................
(6) [ADJUST] POSITIONING 1ST AND 2ND MIRROR
（7）0-S300.........................................................................................................
(8) [ADJUST] AF JOINT STROKE
(9) L2. 0-L101
(10) M301
(11) S1 BLOCK
(12) [ADJUST] VIEWFINDER FOCUS AND PARALLAX..................................................
12-1 --- PARALLAX..
12-2 --- VIEWFINDER FOCUS
(13) [ADJUST] POSITIONING 0-O170 (SI-LED)..............................................................
(14) 0-O100.......................................................................................................................
(15) [ADJUST] POSITIONING 0-O100 (VIEWFINDER INDICATIONS).......................
15-1. PREPARATION......................................................................................................
15-2. ADJUSTMENT.......................................................................................................
(16) 0-M100.......................................................................................................................
(17) 0-J100........................................................................................................................
(18) 0-T940........................................................................................................................
3. ASSEMBLY PROCEDURE OF MAIN BODY................................................................
(1) BASE PLATE OF BODY AND BATTERY CHAMBER............................................
(2) 0-E000 (SHUTTER BLOCK).....................................................................................
76700 -6/94-
page
19
19
19
22
22
23
24
25
25
26
27
27
27
27
27
28
29
29
29
29
30
30
30
31
31
31