Rear Panel Features - Extron electronics SW HDMI Series User Manual

Rear Panel Features

SW2 HDMI
POWER
12V
0.4A MAX
1
Figure 2.
SW4 HDMI
POWER
12V
0.4A MAX
1
Figure 3.
a
b
INPUTS
1 2
2
SW2 HDMI Rear Panel
INPUTS
1 2 3
2
SW4 HDMI Rear Panel
Power connector — Plug the provided external 12 VDC, 1 A power supply into this
2-pole, 3.5 mm captive screw connector and into an AC power outlet.
ATTENTION: Do not connect power to the switcher until you have read the
CAUTION and ATTENTION notices
Video input connectors — Connect HDMI video input sources to these Type A
female single-link HDMI connectors. Data rates of up to 6.75 Gbps are supported.
LockIt brackets: LockIt cable lacing brackets, one for each HDMI input and
®
•
the output connector, are provided with the SW HDMI. These brackets secure the
HDMI cables to the rear panel connectors and reduce stress on the connectors,
preventing signal loss due to loose cable connections. For information on
attaching the LockIt brackets, see the LockIt HDMI Lacing Bracket Installation
Guide, available at www.extron.com.
EDID information: By default, EDID is read from the output device and
•
written to switcher memory for each input, allowing the source to see the EDID
information for the output device even when the output is switched away from it.
NOTE: If power is recycled to the display, or if a new display is connected,
the source may need to be rebooted to read the new EDID.
OUTPUT
3
OUTPUT
4
3
on page 7.
SW HDMI Series • Installation
6
REMOTE
TALLY OUT
+v
1 2 3 4
CONTACT RS-232 AUTO
1 2 3 4 G Tx Rx
4 5
6
REMOTE
TALLY OUT
+v
1 2 3 4
CONTACT RS-232 AUTO
1 2 3 4 G Tx Rx
4 5
5