Extron electronics SW HDMI Series User Manual page 20

c
Input selection buttons and LEDs — Press these buttons to select input 1 or 2
or inputs 1 through 4, depending on your model. The LED at the right of each
button lights when the corresponding input is selected. These buttons are disabled if
auto-input switching is in effect, but the LEDs continue to light to indicate the selected
input.
The input buttons are also used to initiate a system reset (see
and to enable and disable front panel lockout (see
Front Panel (Executive Mode)
d
Signal status LEDs —
Inputs: Each input has a corresponding numbered Signal LED, which lights when
•
a source is connected to the input connector and TMDS clock activity is detected
on it.
NOTE: If the source device connected to the selected input is HDCP
encrypted (requires HDCP authentication), the corresponding signal LED
may not light unless HDCP has been authenticated.
Output: The Output Signal LED lights when a TMDS signal is being transmitted
•
to the connected output device.
e
HDCP status LEDs —
Inputs: Each input has a corresponding numbered HDCP LED. If the connected
•
source requires HDCP, the corresponding LED lights when authentication is
successful.
NOTE: HDCP is authenticated on each input regardless of the currently
selected source.
Output: The Output HDCP LED lights if the currently selected input requires
•
HDCP and the connected output device has been successfully authenticated.
NOTE: HDCP is re-authenticated on the output whenever a new input is
selected.
f
Config port — Connect a USB cable (USB A to mini B) between your computer
and this female USB mini B port to configure and control the switcher via SIS
commands or the Universal Switcher Control Program and to update the firmware
(see Connecting to the USB Port
Locking and Unlocking the
on page 17).
on page 9).
SW HDMI Series • Operation
Resetting on page 16)
14