Extron electronics SW HDMI Series User Manual page 35

7. Depending on the connection method that you selected, additional options appear.
Make the appropriate selections for your connection method.
RS-232: Select the appropriate options from the
•
menus (this information is provided by your system administrator).
USB: Only the
Extron USB Device_0
•
menu. Make sure that it is selected.
Devices
8. Click . If the connection is successful,
Connect
in the Connected Device section, followed by a green check mark.
9. Click the button in the New Firmware File (Optional) section.
Browse
10. On the Open window, navigate to the new firmware file, which has an S19 extension,
and double-click it.
Figure 18. Open Window for Firmware File Selection
ATTENTION: Valid firmware files must have the file extension S19. A file with any
other extension is not a firmware upgrade for this product and could cause the
switcher to stop functioning.
NOTES:
• The original factory-installed firmware is permanently available on the
SW HDMI. If the attempted firmware upload fails for any reason, the
switcher reverts to the factory version.
• When downloaded from the Extron website, by default the firmware is
placed in a folder at:
C:\Program Files\Extron\Firmware\SW HDMI
C:\Program Files (x86)\Extron\Firmware\SW HDMI
option is available on the
SW HDMI Series
SW HDMI Series • Remote Communication and Control
and
Com Port Baud Rate
Available
is displayed in green
(Windows XP) or
(Windows 7).
29